Differential GPS/inertial navigation approach/landing flight testresults

In November 1990, a differential GPS/inertial flight test was conducted to acquire a system performance database and demonstrate automatic landing using an integrated differential GPS/INS with barometric and radar altimeters. Flight test results obtained from postflight data analysis are presented. These results include characteristics of DGPS/inertial error, using a laser tracker as a reference. In addition, data are provided on the magnitude of the differential correlations and vertical channel performance with and without radar altimeter augmentation. Flight test results show one sigma DGPS/inertial horizontal errors of 9 ft and one sigma DGPS inertial vertical errors of 15 ft. Without selective availability effects, the differential corrections are less than 10 ft and are dominated by receiver unique errors over the time period of an approach. Therefore, the one sigma performance of the autonomous GPS (8-ft horizontal and 20-ft vertical) is very similar to the DGPS/inertial performance. Postprocessed results also demonstrate significant improvements in vertical channel performance when GPS/inertial is aided with radar altimeter along with a low-resolution terrain map     

Neutron yields from interactions of GCR-like beams in stopping targets.

In order to accurately determine the radiation risk to astronauts from GCR, the nature of the secondary radiation field created by the fragmentation of GCR in shielding and tissue must be understood. Due to the their high penetrabilities, neutrons are an important component of the secondary radiation field, especially for astronauts protected by thick shielding on lunar or Martian bases. Neutron yields from 435A MeV and 272A MeV Nb stopping in Nb and Al targets are presented, along with some preliminary analysis of neutron yields from 155A MeV C stopping in Al. Energy spectra and angular distributions are shown for neutron energies above 20 MeV. The data provides some information about the dependence of the neutron yield on projectile energy and target mass. Comparisons of the data with BUU calculations are also shown.     

Giotto/Cometary dust interaction event near the comet Halley ionopause

Plasma and magnetic field disturbances accompanying dust particle impacts are explained by means of creation of a secondary cloud around the spacecraft. Cold cometary ions impinging upon the cloud are scattered by atoms of the cloud. This scattering changes initial angular distribution of cometary ions. Magnetic field perturbation is created by the friction between the electron component of the cometary plasma flow and the cloud.     

DNA damage and repair in oncogenic transformation by heavy ion radiation.

Energetic heavy ions are present in galactic cosmic rays and solar particle events. One of the most important late effects in risk assessment is carcinogenesis. We have studied the carcinogenic effects of heavy ions at the cellular and molecular levels and have obtained quantitative data on dose-response curves and on the repair of oncogenic lesions for heavy particles with various charges and energies. Studies with repair inhibitors and restriction endonucleases indicated that for oncogenic transformation DNA is the primary target. Results from heavy ion experiments showed that the cross section increased with LET and reached a maximum value of about 0.02 micrometer2 at about 500 keV/micrometer. This limited size of cross section suggests that only a fraction of cellular genomic DNA is important in radiogenic transformation. Free radical scavengers, such as DMSO, do not give any effect on induction of oncogenic transformation by 600 MeV/u iron particles, suggesting most oncogenic damage induced by high-LET heavy ions is through direct action. Repair studies with stationary phase cells showed that the amount of reparable oncogenic lesions decreased with an increase of LET and that heavy ions with LET greater than 200 keV/micrometer produced only irreparable oncogenic damage. An enhancement effect for oncogenic transformation was observed in cells irradiated by low-dose-rate argon ions (400 MeV/u; 120 keV/micrometer). Chromosomal aberrations, such as translocation and deletion, but not sister chromatid exchange, are essential for heavy-ion-induced oncogenic transformation. The basic mechanism(s) of misrepair of DNA damage, which form oncogenic lesions, is unknown.     

Austrian dose measurements onboard space station MIR and the International Space Station--overview and comparison.

The Atominstitute of the Austrian Universities has conducted various space research missions in the last 12 years in cooperation with the Institute for Biomedical Problems in Moscow. They dealt with the exact determination of the radiation hazards for cosmonauts and the development of precise measurement devices. Special emphasis will be laid on the last experiment on space station MIR the goal of which was the determination of the depth distribution of absorbed dose and dose equivalent in a water filled Phantom. The first results from dose measurements onboard the International Space Station (ISS) will also be discussed. The spherical Phantom with a diameter of 35 cm was developed at the Institute for Biomedical Problems and had 4 channels where dosimeters can be exposed in different depths. The exposure period covered the timeframe from May 1997 to February 1999. Thermoluminescent dosimeters (TLDs) were exposed inside the Phantom, either parallel or perpendicular to the hull of the spacecraft. For the evaluation of the linear energy transfer (LET), the high temperature ratio (HTR) method was applied. Based on this method a mean quality factor and, subsequently, the dose equivalent is calculated according to the Q(LET infinity) relationship proposed in ICRP 26. An increased contribution of neutrons could be detected inside the Phantom. However the total dose equivalent did not increase over the depth of the Phantom. As the first Austrian measurements on the ISS dosimeter packages were exposed for 248 days, starting in February 2001 at six different locations onboard the ISS. The Austrian dosimeter sets for this first exposure on the ISS contained five different kinds of passive thermoluminescent dosimeters. First results showed a position dependent absorbed dose rate at the ISS.     

On Lyapunov stability analyses of the switching regulator/filtersystem

The stability design criteria for the fourth-order switching regulator/low-pass filter system are obtained directly from the solution to the resultant simultaneous equations for the Lyapunov matrix equation. The regulator/filter system is asymptotically stable if the values of the filter components are chosen to satisfy the derived Lyapunov stability design criterion for a given value of the switcher dynamic resistance     

Enzyme conversion of lignocellulosic plant materials for resource recovery in a Controlled Ecological Life Support System.

A large amount of inedible plant material composed primarily of the carbohydrate materials cellulose, hemicellulose, and lignin is generated as a result of plant growth in a Controlled Ecological Life-Support System (CELSS). Cellulose is a linear homopolymer of glucose, which when properly processed will yield glucose, a valuable sugar because it can be added directly to human diets. Hemicellulose is a heteropolymer of hexoses and pentoses that can be treated to give a sugar mixture that is potentially a valuable fermentable carbon source. Such fermentations yield desirable supplements to the edible products from hydroponically-grown plants such as rapeseed, soybean, cowpea, or rice. Lignin is a three-dimensionally branched aromatic polymer, composed of phenyl propane units, which is susceptible to bioconversion through the growth of the white rot fungus, Pluerotus ostreatus. Processing conditions, that include both a hot water pretreatment and fungal growth and that lead to the facile conversion of plant polysaccharides to glucose, are presented.     

AFIT neural network research

A brief summary of research done at the Air Force Institute of Technology (AFIT) in the area of neural networks is provided. It has been shown that backpropagation, used for feedforward artificial neural networks, is just a degenerate version of an extended Kalman filter, and that networks can do about as well as the optimum statistical classification technique. A method of finding the importance of features for use by a neural network classifier has been determined. Techniques for using neural networks for image segmentation have been developed. In optical pattern recognition, techniques that allow the processing of real FLIR (forward-looking infrared) images with existing binary spatial light modulators have been devised. An optical direction of arrival detector applicable to laser illumination direction determination has been designed and tested; the design is similar to a fly's eye. Coated mirrors for the optical confocal Fabry-Perot interferometer have been designed, specified, fabricated, and installed. Significant progress has been made in the use of neural networks for processing multiple-feature sets for speech recognition     

Real-time translational control of a MEMS comb resonator

Closed-loop control has been successfully applied to a microelectromechanical systems (MEMS) lateral comb resonator device in real-time to perform impulse disturbance damping and sinusoidal position control, enabled by the use of a through-wafer optical microprobe to obtain position feedback. This result leverages the application of lifetime, in-situ control of MEMS in order to provide quality assurance of microsystems in safety critical applications. A position feedback signal produced by a through-wafer optical microprobe has been used for comb resonator system model identification by two independent methods to accurately determine the effective mass, damping, and spring constant values of the device. After accurate determination of system parameters, closed-loop impulse disturbance damping and proportional-integral-differential (PID) translational control were applied. Closed-loop control results presented indicate controllability of such microstructures and response times on the order of the natural frequency of the device.